This is a special alloyed, gas-shielded hard-facing welding wire containing "Fe-Cr-Co-Mo" that, thanks to its low coefficient of friction,
provides high resistance to metal-to-metal wear. In addition to resistance to metal-to-metal wear, the weld metal also provides high resistance to oxidation, fatigue, cavitation, and corrosion wear caused by high operating temperatures.
The resulting weld metal is crack-free and achieves the desired hardness
is achieved in the first pass.
DIN 8555: MF5-GF-45 CRST
Hardness: 46–48 HRC (after welding and in a single pass)
– Marine pistons and valves
– Piston ring grooves
– Hot-cutting blades
– Deburring tools
– Hot-forging tools and dies
– Press tools
– Furnace components
– Piercing punches used in steel pipe extrusion
– Pump components
– Filler surfaces of hot-work tools
– Guide rollers and drive rollers used in continuous casting
The surface to be welded must be clean. Thick-walled parts should be preheated to 300–500°C,
and this temperature must be maintained throughout the filler metal application process. After the welding
process is complete, the parts should be cooled slowly.
Benzer Ürünler
Yorum yapabilmek için giriş yapmış ve ürünü satın almış olmanız gerekmektedir.*